Installing laminate flooring on a concrete floor with prime guidelines to laying laminate flooring for each a single who ask How to lay laminate flooring on uneven concrete floor - the operate itself is not complex. Much more hard is the preparation of this operate. Take into account what measures have to take to get a very good basis for a laminate board.
Do not miss :
3D floors and floor murals for bedroom
The reference surface for lay laminate flooring :
What should be the reference surface for lay laminate flooring
Laminate is placed more than the substrate, which in turn is placed on a concrete slab or rough screed. The principal feature of laminate flooring is that it is going from individual dosochnyh elements.
Among these elements are connected by a tongue and groove system. If the base surface contains even minor defects, in the life of the floor grooves with crests start to break down, and a laminated splendor gradually transformed into a set of unrelated boards.
Laying laminate on uneven concrete base is only achievable after a cautious balance it!
On the techniques of leveling floor for laminate
There are three ways leveling subfloors . The very first of these is used, if the elevation adjustments do not exceed two cm It is based on the use of self-leveling mixture (level-mass).
With much more extreme irregularities (2 to 5 cm), the very same leveling leveling mixture is poured over the concrete or screed. Screed necessary in situations where you want to raise the floor at 5-ten cm
If you need to raise the floor level to a height of about 10 cm, employed sheets of plywood or chipboard (the method of "dry" screed).
Take into account how these three techniques are applied in practice.
I recommend to see :
Uncommon self leveling floor covering ideas 2014
Practical aspects of floor leveling
how to lay laminate flooring on a concrete floor or plywood base?
Please note the following:
- prior to pouring the mass-level surface of the slab or screed carefully primed
- leveling compound is prepared in tiny portions
- the portions are interconnected by indicates of a needle roller
- for producing cement screed taken not significantly less than 400 marks
- pouring the concrete layer is performed at a pre-exposed beacons
- topcoat soon after dialing answer consists of the necessary strength
- "Dry" screed is becoming built on leading of damp-proof base
- strategy of "dry screed" demands building of floor joists.
Finally, we note that with laminate should use padded - laying laminate flooring on a concrete floor with a substrate provides a truly trustworthy and good quality floor.
0 comments:
Post a Comment